Tesla Model S: Frame - Panoramic Roof Assembly (Remove and Replace)
READ NEXT:
Warning: To avoid
personal injury, wear cut-resistant gloves when performing this
operation.
Special tools required for this procedure:
Supplier
Installation
Use a scraping tool to remove the majority of
the adhesive from the body, leaving a smooth layer of the original
adhesive approximately 1 mm thick or less.
Warning: To avoid
personal injury, wear cut-resistant gloves when performing this
operation.
Special tools required for this procedure:
Supplier
SEE MORE:
Plug adapter fully into Mobile Connector and retry
Your Mobile Connector is unable to communicate with the wall plug adapter.
Because your Mobile Connector cannot
monitor the wall plug adapter temperature, charge current is automatically
reduced to 8A.
It is recommended that you try the followin
Removal
Remove door handle for access (refer to procedure)
Position handle assembly on a soft working surface.
Remove door handle rear seal.
Remove screws (x4) securing handle grip backplate and remove
(torque 2 Nm).