Tesla Model S: Roof
- Calibration - Panoramic Roof Assembly
- Sliding Glass - Panoramic Roof Assembly (Remove and Replace)
- Fixed Glass - Panoramic Roof Assembly (Remove and Replace)
- Frame - Panoramic Roof Assembly (Remove and Replace)
- Frame - Panoramic Roof Assembly (Remove and Replace) - Removal
- Frame - Panoramic Roof Assembly (Remove and Replace) - Installation
- Side Applique - 1st Generation - LH (Remove and Replace)
- Side Applique - 2nd Generation - LH (Remove and Replace)
- Front Applique - 1st Generation (Remove and Replace)
- Panoramic Roof Drive Cable - LH (Remove and Replace)
- Wind Deflector Arm - LH (Remove and Replace)
- Wind Deflector (Remove and Replace)
- Motor - Sunroof - LH (Remove and Replace)
- Motor - Sunroof - RH (Remove and Replace)
READ NEXT:
Calibration - Panoramic Roof Assembly
Check
Close panoramic roof glass using touch screen.
Connect a laptop with Toolbox to the vehicle.
In Toolbox, select Views > Body/Security >
Panoramic Sunr
Sliding Glass - Panoramic Roof Assembly (Remove and Replace)
Removal
Note: Before beginning
this procedure, prepare a covered surface or workbench to
support the moving glass after it is removed from the vehicle.
Fully
Fixed Glass - Panoramic Roof Assembly (Remove and Replace)
Warning: To avoid
personal injury, wear cut-resistant gloves when performing this
operation.
Warning: To avoid
personal injury, eye protection must be worn when performing this
ope
SEE MORE:
Troubleshooting
Charging does not start. The green "Ready" light in the software
application is dimmed.
Check that the HV power supply is plugged in and turned
on.
Check the connections at the rear of the
charger/interface control box.
Discharging does not start.
Shield - Dust - Brake - Front - 2nd Generation (Retrofit)
Procedure
Remove the front hub assembly
(refer to procedure).
Install the dust shield using the 2 existing
holes in the knuckle (torque 8 Nm).
Use a punch to mark the location of the 3rd
bolt hole onto the knuckle.
© 2019-2026 Copyright www.tesms.org
