Tesla Model S: HV Battery Charge/Discharge - 3rd Generation Tool (Out of Vehicle)
READ NEXT:
Warning: Only technicians who have been trained in High
Voltage Awareness are permitted to perform this procedure. Proper
personal protective equipment (PPE) and insulating HV gloves with a
Starting the System
Press the emergency stop button to disable HV systems.
Pull out the display/keyboard/trackpad tray.
Press the red power button to turn on the on-board PC.
Follo
Select Manual Mode from the Charge/Discharge Mode menu.
Type the desired SOC in the Target SOC% field, or drag the
Target SO
SEE MORE:
Check pressure and refill air as needed
This alert does NOT indicate that there is a flat tire.
The tire pressure monitoring system (TPMS) has detected that the air pressure in
one or more of your tires is at least
20% lower than the recommended cold tire pressure.
See Maintaining Tire Pressures
Removal
Remove IP carrier (refer to procedure)
Disconnect duct temperature sensor harness connector.
Remove screw securing duct to HVAC assembly and position duct
aside (torque 1 Nm).
Disconnect actuator harness