Tesla Model S: Liftgate Glass (Remove and Replace)
READ NEXT:
Warning: To avoid personal injury, wear cut-resistant
gloves when performing this operation.
Note: Use Dow Betaseal Express or an equivalent
fast-curing glass adhesive to perform this proced
Installation
Use the adhesive scraper to remove the excess urethane from the
body.
Temporarily reconnect the CHMSL to the harness in the center of
the liftgate and have an assista
SEE MORE:
Note: This procedure describes how to remove and install
the 2nd generation master charger. If the vehicle is equipped with a
1st generation master charger, refer to procedure 44100202 (refer to
procedure).Warning: Only technicians who have been trained in High
Voltage Awareness are
Removal
Open the hood.
Remove the lower carpet from the underhood storage area.
Remove the upper trim panel by pulling down on the bottom, then
pulling out toward the front of the vehicle.