Tesla Model S: Body
Jack Mode Activation
Setting Procedure- Power up the touchscreen. Note: Suspension height can only be lowered when all doors are closed.
- Touch Controls.
- Touch Suspension.
- Touch Jack.
- Power up the touchscreen.
- Touch Controls.
- Touch Suspension.
- Touch Jack.
- Raise Vehicle - 2 Post Lift
- Raise Vehicle - 4 Post Lift
- Fascia Assembly - Front (Remove and Install)
- Fascia Assembly - Front (Remove and Replace)
- Bumper Assembly - Front (Remove and Replace)
- Ankle Catcher Assembly (Remove and Replace)
- Applique - Fascia - Front - 1st Generation (Remove and Replace)
- Applique - Fascia - Front - 2nd Generation (Remove and Install)
- Applique - Fascia - Front - 2nd Generation (Remove and Replace)
- Grill - Fascia - Front (Remove and Replace)
- Chin Spoiler Assembly (Remove and Replace)
- Fascia Assembly - Rear (Remove and Install)
- Fascia Assembly - Rear (Remove and Replace)
- Bumper Assembly - Rear (Remove and Replace)
- Diffuser Trim - Rear (Remove and Replace)
- Carrier - Bumper - Front (Remove and Replace)
- Strut - Shock Tower to Bulkhead - LH (Remove and Replace)
- Windshield Assembly (Remove and Replace)
- Sensor - Light/Rain (Remove and Replace)
- Fixed Glass - Front Door - LH (Remove and Replace)
- Body Glass - Rear Quarter - LH (Remove and Replace)
- Liftgate Glass (Remove and Install)
- Liftgate Glass (Remove and Replace)
READ NEXT:
Raise Vehicle - 2 Post Lift
Warning: "Jack mode" must be activated on vehicles with air
suspension before lifting the vehicle. Failure to do this might lead
to suspension damage and could cause serious personal injury.
Raise Vehicle - 4 Post Lift
Raise
Position the vehicle centrally between the lift posts.
Warning: To avoid personal injury, use
appropriate equipment when performing this
Fascia Assembly - Front (Remove and Install)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Remove the front underhood apron (refer to
SEE MORE:
Camera - Rear Facing (Remove and Replace)
Removal
Remove the tailgate lower finisher (refer to procedure).
Pull back the watershield for access to the rear camera
electrical connector.
Disconnect the rear camera electrical connector.
Remove the liftgate
Lamp - Side Repeater - Front - LH (Remove and Replace)
Removal
Using a suitable tool carefully release fixing lugs (x2)
securing side repeater to front fender. NOTE: Wheel arch liner
removed for clarity.
Caution: Care must be taken to avoid damage to
paintwork and exterior trim.
Release side re
© 2019-2026 Copyright www.tesms.org
