Tesla Model S: Sentry Mode - View Live Camera
NOTE: View Live Camera requires premium connectivity. It also requires that version 4.2.1 (or newer) of the Tesla mobile app is installed on a phone that has been paired as a key to Model S.
When Sentry Mode is enabled, you can use the mobile app to remotely view the area surrounding Model S as seen through the exterior cameras.
To enable, touch Controls > Safety > Sentry Mode > View Live Camera via Mobile App on the Model S touchscreen. Once enabled, ensure there are no occupants in the vehicle and all doors are closed. Then, on the Tesla mobile app, go to Safety > Sentry Mode and touch View Live Camera to see a live video feed of your vehicle's surroundings.
In addition, if Model S is equipped with a pedestrian warning speaker (see Pedestrian Warning System), you can press and hold the microphone button on the mobile app to transmit your voice through this speaker.
When View Live Camera is actively being used, Model S periodically flashes its exterior lights and displays a message on the touchscreen to notify others that the area surrounding the vehicle is being viewed through the cameras.
View Live Camera is limited to approximately one hour (or 15 minutes for some regions) of cumulative usage per day.
NOTE: Video quality can vary depending on network connectivity. No audio is captured.
NOTE: The live camera feed is fully encrypted and cannot be accessed by Tesla.
READ NEXT:
Viewing Video Recordings
You can view recorded footage on the touchscreen
when Model S is in Park. Touch the Dashcam icon
located in the app launcher or the Dashcam icon on the
Controls screen. Touch the menu icon in the t
About HomeLink
f your vehicle is equipped with
the
HomeLink Universal Transceiver, you can
operate up to three Radio Frequency (RF)
devices, including garage doors, gates,
lights, and security systems.
NOTE: De
SEE MORE:
TPMS Sensor - ID Learn Procedure - Baolong
Setup
Turn on the Tesla SmarTool and select menu item
3 - Wakeup ID.
Starting with the front left wheel, hold the
tool against the tire sidewall, near the valve stem, and press
Enter.
Note: The tool will
ping the sensor and read its uniqu
Master Cylinder and Reservoir Assembly (Remove and Install)
Note: This procedure
applies to vehicles with the vacuum brake booster only. If the
vehicle has the electromechanical brake booster assembly, the
master cylinder and reservoir assembly are part of the brake
booster assembly. Refer to procedure 33031402
(refer to procedure).
