Tesla Model S: Dashcam and Sentry Mode
NOTE: Depending on market region, vehicle configuration, options purchased, and software version, your vehicle may not be equipped with Dashcam or Sentry Mode or the features may not operate exactly as described. Please note it is your sole responsibility to consult and comply with all local regulations and property restrictions regarding the use of cameras.
In addition to supporting Autopilot, the exterior cameras can record and store video footage of the vehicle's surroundings on a USB flash drive. This can be convenient in situations where you want a video recording of a particular incident. If set to AUTO, Dashcam saves video recordings of collisions when driving. On the other hand, if enabled, Sentry Mode is the alarm system that monitors the environment around your vehicle when it is locked and in Park. After an incident is detected, Sentry Mode responds according to the level of threat detected.
NOTE: For saving Sentry Mode and Dashcam footage, Tesla recommends using the USB port located in the glovebox. Doing so increases security and minimizes power consumption.
NOTE: You can use the glovebox USB port to store a combination of dashcam, Sentry Mode, and Track Mode content in addition to audio files.
NOTE: Dashcam and Sentry Mode will not record video when Dashcam is OFF.
NOTE: To protect your privacy, video recordings are saved locally to onboard memory or the USB flash drive. Recordings are not sent to Tesla.
READ NEXT:
Using Dashcam
Dashcam records footage of your vehicle's surroundings
when the touchscreen is powered on (see Starting and
Powering Off). Dashcam does not record
video when your vehicle is powered off. Use Dashca
Using Sentry Mode
When Sentry Mode is turned on, the cameras and
sensors remain powered on and ready to record
suspicious activity around your vehicle when Model S is
locked and in Park.
To store and retrieve Sentry
Sentry Mode - View Live Camera
NOTE: View Live Camera requires premium connectivity.
It also requires that version 4.2.1 (or newer) of the Tesla
mobile app is installed on a phone that has been paired
as a key to Model S.
When S
SEE MORE:
Actuator - Latch - Hood - LH (Dual Motor) (Remove and Replace)
Removal
Remove the ankle catcher (refer to procedure).
Remove the LH and RH condenser ducts (refer to procedure).
Remove the plastic rivets (x3) that secure the center louver
assembly.
Note: The following image shows the center
louver assembly from the rear.
TXV Valve - Evaporator (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure)
Remove underhood storage unit (refer to procedure)
Remove nut securing pipe retaining plate to evaporator TXV
(torque 22 Nm).
Remove bolt securing A/C pipe bracket to cross-brace (torque 6
Nm).
