Tesla Model S Owners & Service Manuals

Tesla Model S: Bash Plate - Front - Extrusion (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / Chassis / Bash Plate - Front - Extrusion (Remove and Replace)

Removal

  1. Raise and support the vehicle (refer to procedure).
  2. Remove and discard the bolts (x2) that secure the bash plate extrusion to the front subframe (10 Nm).

    Bash Plate - Front - Extrusion (Remove and Replace)

  3. Remove the bash plate extrusion.
Installation

Installation procedure is the reverse of removal.

Note: Use new bolts to install the bash plate extrusion. Do not reuse any bolts.

    READ NEXT:

     Suspension

     Four Wheel Alignment Check

     Four Wheel Alignment Check - Preparation

    Note: This procedure is not specific to a particular alignment machine. Follow the alignment equipment manufacturer's instructions for additional information and safety instructions.

    SEE MORE:

     Battery Care

    Never allow the Battery to fully discharge. Even when Model S is not being driven, its Battery discharges very slowly to power the onboard electronics. The Battery can discharge at a rate of approximately 1% per day, though the discharge rate may vary depending on environmental factors (such as

     Four Wheel Alignment - Check and Adjust

    Note: This procedure is not specific to a particular alignment machine. Follow the alignment equipment manufacturer's instructions for additional information and safety instructions. Special tool(s) required for this procedure: Supplier Part Number

    © 2019-2026 Copyright www.tesms.org