Tesla Model S: Suspension
Tesla Model S (2012-2026) Service Manual / Suspension
- Four Wheel Alignment Check
- Four Wheel Alignment - Check and Adjust
- Ride Height - Adjust
- Suspension - Front - Check Torque
- Knuckle - Suspension - Front - LH (Remove and Replace)
- Hub - Front - LH (Remove and Replace)
- Link - Sway Bar - Front - LH (Remove and Replace)
- Sway Bar - Front (RWD) (Remove and Replace)
- Sway Bar - Front (Dual Motor) (Remove and Replace)
- Control Arm - Upper - Front - LH (Remove and Replace)
- Control Arm - Upper - Front - RH (Remove and Replace)
- Link - Lower - Fore - LH (Remove and Replace)
- Link - Lower - Aft - LH (Remove and Replace)
- Suspension - Rear - Check Torque
- Knuckle - Suspension - Rear - LH (Remove and Replace)
- Hub - Rear - LH (Remove and Replace)
- Control Arm Assembly - Rear - Lower - LH (Remove and Replace)
- Link - Suspension - Rear - Upper - LH (Remove and Replace)
- Toe Link Assembly - Rear - LH (Remove and Replace)
- Drop Link - Sway Bar - Rear - LH (Remove and Replace)
- Integral Link - Rear - LH (Remove and Replace)
- Air Spring Module - Front - LH (Remove and Replace)
- Air Spring Module - Rear - LH (Remove and Replace)
- Air Suspension - Pressurize/Depressurize - One Air Spring
- Air Suspension - Depressurize - Full System
- Air Suspension - Pressurize - Full System
- Compressor - Air Suspension (Remove and Replace)
- Sensor - Ambient Air Temperature - Compressor (Remove and Replace)
- Solenoid - Air Suspension (Remove and Replace)
- Reservoir - Air Suspension (Remove and Replace)
- Sensor - Ride Height - Front - LH (Remove and Replace)
- Sensor - Ride Height - Rear - LH (Remove and Replace)
- Air Line - Air Suspension - Valve Block to LH Front Air Spring (Remove and Replace)
- Air Suspension - Primary Lines Assembly (Remove and Replace)
- Air Line - Air Suspension - Reservoir to Compressor (Remove and Replace)
- Air Line - Air Suspension - Compressor to Valve Block (Remove and Replace)
- Air Line - Air Suspension - Valve Block Exhaust (Remove and Replace)
- Spring and Damper Assembly - Front - LH (Remove and Replace)
- Spring and Damper Assembly - Rear - LH (Remove and Replace)
READ NEXT:
Four Wheel Alignment Check - Preparation
Note: This procedure
is not specific to a particular alignment machine. Follow the
alignment equipment manufacturer's instructions for additional
information and safety instructions.
Alignment Check
Raise the alignment platform until it is clear
of all 4 rack locks.
Lower the alignment platform onto the rack
locks and ensure that it is level.
Secure all 4 alignment
SEE MORE:
Skidplate - Front (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Removal
Remove front aero shield
(refer to procedure).
If equipped, remove the bash plate stamping
(refer to procedure).
Switch - Hazard Warning (Remove and Replace)
Removal
Remove touch screen surround trim (refer to procedure)
Release hazard warning switch from substrate and disconnect
harness connector from switch.
Remove switch.
Installation
Installation procedure is the reverse of removal.
© 2019-2026 Copyright www.tesms.org
