Tesla Model S: Carpet - Underhood Storage (Dual Motor) (Remove and Install)
Removal
- Peel back the carpeting at the front of the underhood storage
unit.
- Disconnect the emergency hood release and front light harnesess.
- Remove the underhood storage carpet from the vehicle.
Installation
Installation procedure is the reverse of removal, except for the
following:
Secure the edges of the carpet under the seal.
READ NEXT:
Removal
Remove driver seat (refer to procedure)
Remove passenger seat.
Remove driver footrest (refer to procedure)
Remove LH sill panel trim (refer to procedure)
Remove RH sil
Warning: Only technicians who have been trained in High
Voltage Awareness are permitted to perform this procedure. Proper
personal protective equipment (PPE) and insulating HV gloves with a
SEE MORE:
Removal
Remove the front fascia assembly (refer to procedure).
Set the fascia assembly on a flat, clean surface.
Disconnect the parking distance sensor connector.
Carefully release the parking di
Roll the right scroll wheel up to increase, or down to
decrease, the set speed. Slowly rolling the scroll wheel
changes the set speed in 1 mph (1 km/h) increments and
quickly rolling the scroll wheel changes the set speed to
the closest 5 mph (5 km/h) increment.
NOTE: It may take a few seconds