Tesla Model S: Front Drive Unit (From Above) (Remove and Install)
Tesla Model S (2012-2026) Service Manual / Front Drive Unit / Front Drive Unit (From Above) (Remove and Install)
- Remove Components For Access
- Remove Front Drive Unit
- Front Drive Unit (From Above) (Remove and Install) - Installation
READ NEXT:
Remove Components For Access
Note: If possible, use the
"From Below" procedure to remove and install the front drive unit
(refer to procedure).
Special tools required for this procedure:
Su
Remove Front Drive Unit
Position the support jack on top of the front
crossmember and secure the 2 screws to the front crossmember.
The support jack mounts to the bolt holes on top of the fron
Front Drive Unit (From Above) (Remove and Install)
- Installation
Installation
Use alcohol wipes to clean the mating surfaces
between the RH motor mount and drive unit.
Ensure that the support jack is secured to the
front crossmember.
SEE MORE:
PCB - Door - Exterior Handle - Front - LH (Remove and Replace)
Removal
Remove fork and control link for acces (refer to procedure)
Remove screws (x3) securing PCB to housing (torque 1.5 Nm).
Release PCB pressure sensor from housing and disconnect wiring.
Remove assembly
Module - Air Suspension - ECU (Remove and Replace)
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed position.
Failure to follow this instruction could result in door glass
shatter.
Note: Before disconnecting the 12V power supply,
ensure that the driver's door window
© 2019-2026 Copyright www.tesms.org
