Tesla Model S: Liftgate Glass (Remove and Install)
Tesla Model S (2012-2026) Service Manual / Body / Liftgate Glass (Remove and Install)
READ NEXT:
Liftgate Glass (Remove)
Warning: To avoid personal injury, wear cut-resistant
gloves when performing this operation.
Note: Use Dow Betaseal Express or an equivalent fast-curing
glass adhesive to perform this proced
Liftgate Glass (Install)
Installation
Use the adhesive scraper to remove the excess urethane from the
liftgate glass and body.
Temporarily reconnect the CHMSL to the harness in the center of
the liftgate
SEE MORE:
Jackshaft Assembly - Front (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Remove the RH driveshaft assembly (refer to procedure).
Release the bolts (x2) that secure the jackshaft to the drive
unit (torque 30 Nm).
Brake Hose - Flexible - Rear - LH (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Removal
Remove the rear wheel arch liner
(refer to procedure).
Clean the areas that surround the connections
at each end of the
© 2019-2026 Copyright www.tesms.org
