Tesla Model S: Nozzle - Windshield Washer Jet (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Electrical / Nozzle - Windshield Washer Jet (Remove and Replace)
Removal
- Remove the hood acoustic panel (refer to procedure).
- Disconnect the washer jet pipe from the T-piece.
- Release the clip that secures the jet to the hood. Remove the
jet from the hood.
- Disconnect the washer pipe from the washer jet.
- Check and adjust the washer jet.
READ NEXT:
Sensor - Level - Windshield Washer Reservoir (Remove and Replace)
Removal
Remove the front LH upper wheel arch liner (refer to procedure).
Position a container to collect any spillage.
Disconnect the level sensor connector.
Wiper Blades - Pair (Remove and Replace)
Removal
Use the touchscreen to set the wipers to Service Mode.
Press one wiper arm clip and release the blade.
Remove the wiper blade from the wiper arm.
Wiper Arms - Pair (Remove and Replace)
Special tools recommended for this procedure:
Supplier
Part Number
Description
Tesla
10558
SEE MORE:
Camera Location
Model S is equipped with a rear view camera located
above the rear license plate.
Whenever you shift into Reverse, the touchscreen
displays the view from the camera. Lines show your
driving path based on the position of the steering yoke.
These lines adjust as you move the steering yoke.
Model
Sensor - Ride Height - Rear - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Remove the road wheel (refer to procedure).
Disconnect the ride height sensor connector and harness.
Remove the nut that secures the link t
© 2019-2026 Copyright www.tesms.org
