Tesla Model S: Sensor - Level - Windshield Washer Reservoir (Remove and Replace)
Removal
- Remove the front LH upper wheel arch liner (refer to procedure).
- Position a container to collect any spillage.
- Disconnect the level sensor connector.
- Remove the level sensor from the washer reservoir.
Note: Inspect the O-ring for damage and
replace if necessary.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Use the touchscreen to set the wipers to Service Mode.
Press one wiper arm clip and release the blade.
Remove the wiper blade from the wiper arm.
Special tools recommended for this procedure:
Supplier
Part Number
Description
Tesla
10558
If the wiper blades streak or chatter during cycling, perform the following:
Use the touchscreen to set the wipers to Service Mode.
Clean the wiper blades thoroughly with isopropyl alcohol wipes o
SEE MORE:
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed
position. Failure to follow this instruction could result in
door glass shatter.
Note: Before disconnecting the 12V power supply,
ensure that the driver's door window
Removal
Lower window glass.
Using a suitable tool release outer belt seal, release leading
edge and work rearward.
Caution: Protect paintwork from possible damage during
this procedure.
Caution: Take care not to damage component(s).