Tesla Model S: 200A Fuses - Wall Connector (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / External Charging Connectors / 200A Fuses - Wall Connector (Remove and Replace)
- 200A Fuses - Wall Connector (Remove and Replace) - Removal
- 200A Fuses - Wall Connector (Remove and Replace) - Installation
READ NEXT:
200A Fuses - Wall Connector (Remove and Replace) - Removal
Removal
Warning: Only technicians who have been trained in High
Voltage Awareness are permitted to perform this procedure.
Proper personal protective equipment (PPE) and insula
200A Fuses - Wall Connector (Remove and Replace) - Installation
Installation
Clean the contact surfaces of the new upper and lower bus bars
with alcohol wipes.
Position the new inner fuse. Install the screw at the L2
terminal (torque 3 Nm).
Firmware Update - CHAdeMO Charging Adapter
Tools required:
12V power supply
Laptop with Toolbox 2.0 or higher
USB-CAN dongle
CHAdeMO CAN programming connector
CAN Setup
Connect the USB-CAN dongle to a laptop that i
SEE MORE:
Bracket - Vacuum Pump (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Removal
Remove the front skid plate
(refer to procedure).
Remove the bolts (x2) that secure the vacuum
pump mounting bracket to
Pipe - Low Pressure - Chiller (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure)
Remove front skid plate (refer to procedure)
Remove nut (x1) securing pipe retaining plate to chiller TXV
(torque 12 Nm).
Disconnect refrigerant
© 2019-2026 Copyright www.tesms.org
