Tesla Model S: Air Line - Air Suspension - Valve Block Exhaust (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Suspension / Air Line - Air Suspension - Valve Block Exhaust (Remove and Replace)
Removal
- Raise and support the vehicle (refer to procedure).
- Remove the underhood storage unit (refer to procedure).
- Release the fitting from the valve block (torque 3.5 Nm).
Caution: Plug the line connection to prevent ingress of moisture or dirt.
- Release the air line clip.
Installation procedure is the reverse of removal, except for the following:
- Install a new fitting into the valve block before installing
the air line.
Note: Ensure that the collet is 4.3 mm from the end of the air line to prevent air pressure restriction.
READ NEXT:
Spring and Damper Assembly - Front - LH (Remove and Replace)
Removal
Remove the front road wheel (refer to procedure).
Lower the vehicle.
Remove the underhood apron (refer to procedure).
Remove the nuts (x3) that secure the coil spring modu
Spring and Damper Assembly - Rear - LH (Remove and Replace)
Removal
Remove the LH rear wheelarch liner (refer to procedure).
Remove the parking brake caliper (refer to procedure).
Remove the mid aero shield (refer to procedure).
Remove the
SEE MORE:
Knuckle - Suspension - Rear - LH (Remove and Replace)
Removal
Remove rear brake dust shield (refer to procedure)
Remove nut and bolt securing toe link arm to knuckle (torque 130
Nm).
Remove nut and bolt securing integral link to knuckle (torque
130 Nm).
Remove nut and bolt securing lower control arm to knuckle
(torque 1
Collision Avoidance Assist
The following collision avoidance features are designed
to increase the safety of you and your passengers:
Forward Collision Warning - provides visual and
audible warnings in situations when Model S detects
that there is a high risk of a frontal collision.
Automatic Emergency Braking - autom
© 2019-2026 Copyright www.tesms.org
