Tesla Model S: Bushing - Drive Unit - Front (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Rear Drive Unit / Bushing - Drive Unit - Front (Remove and Replace)
READ NEXT:
Bushing Removal, Front Motor Mount
Warning: To avoid personal injury, eye protection must
be worn when performing this operation.Warning: To avoid personal injury, safety-toe shoes and
cut-resistant gloves are recommended whe
Bushing Installation, Front Motor Mount
Use brake cleaner to clean the threaded rod and the nut bearing
assemblies.
Use 3M Spray Lube 08878 or equivalent to lubricate the threaded
rod and the nut bearing assemblies.
Slid
SEE MORE:
Handle - Exterior Release - Door - Rear - LH (Remove and Replace)
Removal
Remove regulator assembly (refer to procedure)
Make sure exterior release handle is fully retracted.
Disconnect handle harness connector.
Remove nuts (x4) securing door release assembly to reinforcement
(torque 9 Nm).
Carefully release door handle assembly from d
200A Fuses - Wall Connector (Remove and Replace) - Installation
Installation
Clean the contact surfaces of the new upper and lower bus bars
with alcohol wipes.
Position the new inner fuse. Install the screw at the L2
terminal (torque 3 Nm).
Install the inner wire's ring lug on the inner contactor stud.
Caution: Position both
© 2019-2026 Copyright www.tesms.org
