Tesla Model S: Bushing - Drive Unit - Rear (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Rear Drive Unit / Bushing - Drive Unit - Rear (Remove and Replace)
READ NEXT:
Bushing Removal, Rear Motor Mount
Warning: To avoid personal injury, eye protection must
be worn when performing this operation.Warning: To avoid personal injury, safety-toe shoes and
cut-resistant gloves are recommended whe
Bushing Installation, Rear Motor Mount
Use brake cleaner to clean the threaded rod and the nut bearing
assemblies.
Use 3M Spray Lube 08878 or equivalent to lubricate the threaded
rod and the nut bearing assemblies.
Slid
Sensor - Motor - Speed (Remove and Replace)
Removal
Remove the mid aero shield (refer to procedure).
Disconnect the speed sensor connector.
Remove the bolt that secures the speed sensor to the end bell
(torque 8 Nm).
SEE MORE:
Knuckle - Suspension - Rear - LH (Remove and Replace)
Removal
Remove rear brake dust shield (refer to procedure)
Remove nut and bolt securing toe link arm to knuckle (torque 130
Nm).
Remove nut and bolt securing integral link to knuckle (torque
130 Nm).
Remove nut and bolt securing lower control arm to knuckle
(torque 1
Panel - Door Trim - LH - Rear (Remove and Replace)
Removal
Remove the rear window lift switch (refer to procedure).
Release the clips (x4) that secure the speaker cover to the door
trim.
Caution: Take care not to damage component(s).
Carefully remove the sp
© 2019-2026 Copyright www.tesms.org
