Tesla Model S: Calibration - Front Radar Sensor
Tesla Model S (2012-2026) Service Manual / Electrical / Calibration - Front Radar Sensor
READ NEXT:
Vertical Alignment
Special tools required for this procedure:
Supplier
Part Number
Description
Tesla
1056984-
Horizontal Alignment
Note: Perform the "Vertical Alignment" procedure
before performing the "Horizontal Alignment" procedure.
Connect a laptop with Toolbox 2.0 or later to the vehicle.
Perform the Radar
Casing - Transmitter - Remote Keyless Entry (RKE)
Caution: Perform this procedure while using the proper anti-electrostatic
discharge equipment. Refer to TN-14-92-003, "Electrostatic Discharge
Tooling".
Removal
Remove the transm
SEE MORE:
Rear Reading Lights
Model S is equipped with a reading light on each side of
the rear seats, located above the door and next to the
coat hangers (see Coat Hangers ). To turn a
reading light on or off, press its lens. If you leave a
reading light turned on, it automatically turns off when
Model S powers off.
Headli
Sensor - Impact - B Pillar (Remove and Replace)
Removal
Remove the B-pillar lower trim (refer to procedure).
Disconnect the impact sensor harness connector.
Remove the bolt that secures the impact sensor to the B-pillar
(torque 8 Nm).
Caution: The bolt is left-hand threaded / reverse
threaded.
© 2019-2026 Copyright www.tesms.org
