Tesla Model S: Calibration - Panoramic Roof Assembly
Tesla Model S (2012-2026) Service Manual / Roof / Calibration - Panoramic Roof Assembly
Check
- Close panoramic roof glass using touch screen.
- Connect a laptop with Toolbox to the vehicle.
- In Toolbox, select Views > Body/Security > Panoramic Sunroof, then select "Calibrate". The sunroof opens and closes.
- When calibration is complete, disconnect the laptop with Toolbox from the vehicle.
If the entire roof frame has been changed: Ensure the sliding panel does not foul or lift the rubber seal on the fixed glass panel as it opens. This must be conducted before the urethane sealant cures. Adjust frame locally to achieve desired operation.
READ NEXT:
Sliding Glass - Panoramic Roof Assembly (Remove and Replace)
Removal
Note: Before beginning
this procedure, prepare a covered surface or workbench to
support the moving glass after it is removed from the vehicle.
Fully
Fixed Glass - Panoramic Roof Assembly (Remove and Replace)
Warning: To avoid
personal injury, wear cut-resistant gloves when performing this
operation.
Warning: To avoid
personal injury, eye protection must be worn when performing this
ope
SEE MORE:
Drive Unit - Rear - Large (Remove and Install)
Special tools required for this procedure:
Supplier
Part Number
Description
Tesla
1000991
Axle Extractor
Note: Use 1000991 for a large drive unit only.
Charge rate reduced - Handle temperature high
Check charge handle or charge port for debris
Charge current has been temporarily reduced because the Mobile Connector has
detected increased temperature in
the charge handle that connects to your vehicle's charge port.
Make sure the Mobile Connector is fully inserted into your vehicle's charge p
© 2019-2026 Copyright www.tesms.org
