Tesla Model S: Cover - Back Rest - Driver's Seat (Remove and Install)
Tesla Model S (2012-2026) Service Manual / Seats / Cover - Back Rest - Driver's Seat (Remove and Install)
READ NEXT:
Cover - Back Rest - Driver's Seat (Remove)
Removal
Prepare a padded work area
Remove the driver's seat assembly (refer to procedure). With an
assistant, place the seat onto a padded work area so that the
plastic seat back
Cover - Back Rest - Driver's Seat (Install)
Installation
Install new fir tree clips (x4) into the new seat back:
Position the fir tree clip into the bracket.
Trim - Cushion
Trim - Cushion - Driver's Seat (Remove and Replace)
Removal
Note: This component cannot be serviced individually. To
service this component, perform the following:
SEE MORE:
Fascia Assembly - Rear (Remove and Install)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Position the vehicle in preparation for raising it, but keep the
vehicle at ground level at this time.
Peel back the bottom of the lift
Door Glass - RH - Rear - Adjust
Removal
Remove door trim pad (refer to procedure)
Partially lower glass for access to glass clamp.
Remove water proof tape for access to adjustment clamp.
Loosen but do not remove clamp nut securing door glass to
regulator (torque 7.5 Nm). This allows glass to move fore and
© 2019-2026 Copyright www.tesms.org
