Tesla Model S: Trim - Cushion
Trim - Cushion - Driver's Seat (Remove and Replace)
Removal
Note: This component cannot be serviced individually. To
service this component, perform the following:
Replace the driver's seat trim and foam assembly (refer to
procedure).
Installation
Installation procedure is the reverse of removal.
Trim - Cushion - Front Passenger's Seat (Remove and Replace)
Removal
Note: This component cannot be serviced
individually. To service this component, perform the
following:
Refer to one of the following:
- North America: Replace the
passenger's seat base assembly (refer to procedure).
- Europe/Asia Pacific: Replace the
passenger's seat trim and foam assembly (refer to
procedure).
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Foam - Cushion - Driver's Seat (Remove and Replace)
Removal
Note: This component cannot be serviced
individually. To service this component, perform the
following:
Removal
Remove LH pivot lock (refer to procedure)
Release and remove latch cover from seat back.
Carefully release cove
Removal
Remove pivot lock (refer to procedure)
Release and remove latch cover from seat back.
Carefully release cover f
SEE MORE:
To prevent damage to the paint, immediately remove
corrosive substances (bird droppings, tree resin, dead
insects, tar spots, road salt, industrial fallout, etc.). Do
not wait until Model S is due for a complete wash. If
necessary, use denatured alcohol to remove tar spots
and stubborn grease s
Note: This procedure describes how to remove and replace
the 1st generation rear view mirror. If the vehicle is equipped with
a 2nd generation rear view mirror, refer to procedure 15050502 (refer
to procedure).
Removal
Cover the dash assembly to avoid damage.