Tesla Model S Owners & Service Manuals

Tesla Model S: Seats

READ NEXT:

 Motor - Seat Tilt - Driver's Seat (Remove and Replace)

Removal Remove the driver's seat (refer to procedure). Place the seat on a clean work surface. Remove the screw that secures the inner side cover to the seat (torque 1 Nm).

 Motor - Seat Height - Driver's Seat (Remove and Replace)

Removal Power the seat fully upward, away from the floor. Remove the driver's seat outer side cover (refer to procedure). Disconnect the seat height motor connector and harness.

 Switch - Seat Height Adjust - Driver's Seat (Remove and Replace)

Removal Remove driver seat outer side cover (refer to procedure) Remove screws (x3) securing lumbar adjust switch to cover (torque 1 Nm).

SEE MORE:

 Panel - A Pillar Trim - Middle - LH (Remove and Replace)

Removal Position vehicle with clear access to door assembly. Open vehicle door. Remove LH instrument panel side cover (refer to procedure) Release location pins (x2). Caution: Take care not to damage component(s).

 Buckle Assembly - 3rd Row - LH (Remove and Replace)

Warning: Prior to disconnection of 12 volt power supply, ensure driver's door glass is in the fully open position. Failure to follow this instruction could result in vehicle lockout. Warning: If 12 volt power supply is disconnected, do not attempt to open any doors with door glass in

© 2019-2026 Copyright www.tesms.org