Tesla Model S Owners & Service Manuals

Tesla Model S: Footrest - Driver's (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / Interior trim / Footrest - Driver's (Remove and Replace)

Removal

  1. Position driver's seat fully rearward for access.
  2. Using a suitable trim tool release clips (x3) securing footrest to mounting.

    Footrest - Driver's (Remove and Replace)

  3. Remove footrest.
Installation
  1. Installation procedure is the reverse of removal.
  2. Return driver's seat to suitable position.

    READ NEXT:

     Assembly - Closeout Extension - LH - Center Console (Remove and Replace)

    Removal Remove LH wrapped panel trim (refer to procedure) Remove mat from footwell. Release clips (x8) and adhesive pad (x1) securing closeout extension to console. Ca

     Cup Holder (Remove and Replace)

    Removal Remove center console assembly (refer to procedure) Position center console on suitable clean bench to prevent damage. Caution: Take care not to damage component(s

     Trim - Center Console - Rear (Remove and Replace)

    Removal Carefully release clips (x8) securing rear end console closing trim to chassis. Caution: Take care not to damage component(s). Caution: Replace any broke

    SEE MORE:

     Liftgate Glass (Install)

    Installation Use the adhesive scraper to remove the excess urethane from the liftgate glass and body. Temporarily reconnect the CHMSL to the harness in the center of the liftgate and have an assistant depress the brake pedal. Ensure that the CHMSL lights up properly. If any

     Actuator - Mode (Remove and Replace)

    Removal Remove IP carrier (refer to procedure) Disconnect duct temperature sensor harness connector. Remove screw securing duct to HVAC assembly and position duct aside (torque 1 Nm). Disconnect actuator harness

    © 2019-2026 Copyright www.tesms.org