Tesla Model S: Lamp - Side Repeater - Front - LH (Remove and Replace)
Removal
- Using a suitable tool carefully release fixing lugs (x2)
securing side repeater to front fender. NOTE: Wheel arch liner
removed for clarity.
Caution: Care must be taken to avoid damage to
paintwork and exterior trim.
- Release side repeater from fender.
- Disconnect side repeater connector.
- Remove side repeater.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Remove rear fascia assembly for access (refer to procedure)
Release clips (x2) securing reflex lamp to rear fascia.
Remove reflex lamp.
Position the vehicle for adjusting the fog lamps:
In a darkened area.
On a level surface.
Perpendicular to a wall that has a matte white
surface. The
Removal
Remove the front fascia (refer to procedure).
Release the clips (x4) that secure the fascia harness to the fog
lamp assembly.
Disconnect the fog lamp harness connector.
SEE MORE:
Note: This procedure is not specific to a particular alignment
machine. Follow the alignment equipment manufacturer's instructions for
additional information and safety instructions.
Special tool(s) required for this procedure:
Supplier
Part Number
Note: In the event of a
stuck caliper or motor failure, refer to one of these procedures to
release the caliper:
Rear Park Brake Caliper - Caliper Seized/Motor Failure - Release
(33051005)
Caution: This method
requires replacing the caliper after it has be