Tesla Model S: Lamp - Reflex - Rear - LH (Remove and Replace)
Removal
- Remove rear fascia assembly for access (refer to procedure)
- Release clips (x2) securing reflex lamp to rear fascia.
- Remove reflex lamp.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Position the vehicle for adjusting the fog lamps:
In a darkened area.
On a level surface.
Perpendicular to a wall that has a matte white
surface. The
Removal
Remove the front fascia (refer to procedure).
Release the clips (x4) that secure the fascia harness to the fog
lamp assembly.
Disconnect the fog lamp harness connector.
Removal
Remove the front underhood apron (refer to procedure).
Remove the bolt that secures the horn to the bracket (torque 8
Nm).
SEE MORE:
Voltage too high / Try a different wall outlet
The vehicle cannot charge, or charging is interrupted, because either the
Mobile Connector:
Detects the wall outlet voltage is too high.
OR
Detects an unexpected increase in supply voltage from the wall outlet.
Try charging the vehicle with a dif
Component removal
Whenever possible, clean components and surrounding area before removal.
Cap off openings exposed by component removal.
Immediately seal fuel, oil or hydraulic lines when apertures are
exposed; use plastic caps or plugs to prevent loss of fluid and
ingress of dirt.