Tesla Model S: LF Antenna - Dash - Front - LH (Remove and Replace)
Removal
- Remove the instrument panel side cover assembly (refer to
procedure).
- Remove the screws (x2) that secure the antenna to the side cover
(torque 1 Nm).
- Remove the LF antenna from the side cover assembly.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Depress button and fold 60% part of seat back forward.
Lift sufficient heelboard floor covering for access to LF
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to procedu
Removal
Remove touch screen surround trim (refer to procedure)
Release hazard warning switch from substrate and disconnect
harness connector from switch.
Remove switch.
SEE MORE:
Removal
Remove door inner belt glass seal (refer to procedure)
Remove adhesive patches (x3) from glass access openings.
Remove screws (x2) securing door access panel (torque 4 Nm).
Remove access panel.
Lower
When Model S is stopped, Vehicle Hold can continue to
apply the brakes even after you remove your foot from
the brake pedal. When driving on a hill or on a flat
surface, brake as you normally would. After coming to a
complete stop, simply press the brake pedal again (until
the instrument panel