Tesla Model S: Switch - Hazard Warning (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Electrical / Switch - Hazard Warning (Remove and Replace)
Removal
- Remove touch screen surround trim (refer to procedure)
- Release hazard warning switch from substrate and disconnect harness connector from switch.
- Remove switch.
Installation procedure is the reverse of removal.
Switch - Glove Box (Remove and Replace)
RemovalRemoval of the glove box switch is identical to the hazard warning switch (refer to procedure) Installation
Installation procedure is the reverse of removal.
READ NEXT:
Power Socket 12V - Center Console - Rear (Remove and Replace)
Removal
Power driver's seat fully forward for access.
Release clips (x10) securing driver's side upper center console
trim to substrate.
Switch Pack - Driver's (Remove and Replace)
Removal
Remove driver's side door trim (refer to procedure)
Move acoustic pad aside to access door trim.
Caution: Take care not to damage component(s).
Switch - Window Lift - Front Passenger's (Remove and Replace)
Removal
Remove passenger door trim. Removal of passenger door trim is
similar to driver's door (refer to procedure)
Move acoustic pad aside to access door trim.
Caution: T
SEE MORE:
Factors Affecting Energy
Consumption
While driving:
Elevated driving speed.
Environmental conditions such as cold or hot weather
and wind.
Using climate controls to heat or cool the cabin.
Uphill travel: Driving uphill requires more energy and
depletes range at a faster rate. However, driving
downhill allows your vehicle to
Condenser - Gas Cool (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure)
Remove front aero shield panel (refer to procedure)
Remove front LH wheel arch liner (refer to procedure)
Remove bolts (x2) securing front bumper panel support bar and
remove (torque 11 Nm).
© 2019-2026 Copyright www.tesms.org
