Tesla Model S: Mount - Front Drive Unit - LH (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Front Drive Unit / Mount - Front Drive Unit - LH (Remove and Replace)
- Mount - Front Drive Unit - LH (Remove and Replace) - Removal
- Mount - Front Drive Unit - LH (Remove and Replace) - Installation
READ NEXT:
Mount - Front Drive Unit - LH (Remove and Replace) - Removal
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed position.
Failure to follow this instruction could result in door glass
shat
Mount - Front Drive Unit - LH (Remove and Replace) - Installation
Installation
Loosen the bolts that secure the 2 sections of the LH motor
mount.
Set the new motor mount into position.
Secure the 3 bolts that secure the motor to the LH motor moun
Mount - Front Drive Unit - LH (Adjust)
Note: This procedure assumes that the RH mount has been
replaced, but that the shim tools cannot be repositioned to verify
proper clearance. If this happens, follow this procedure to adjust
SEE MORE:
Troubleshooting
Charging does not start. The green "Ready" light in the software
application is dimmed.
Check that the HV power supply is plugged in and turned
on.
Check the connections at the rear of the
charger/interface control box.
Discharging does not start.
Speed Limit Mode
Speed Limit Mode allows you to limit acceleration and
limit the maximum driving speed to a chosen value
between 50 and 120 mph (80 and 193 km/h). The first
time you use this feature, you must create a 4-digit PIN
that you must use to enable and disable Speed Limit
Mode. When enabled and the dri
© 2019-2026 Copyright www.tesms.org
