Tesla Model S: Mount - Front Drive Unit - RH (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Front Drive Unit / Mount - Front Drive Unit - RH (Remove and Replace)
- Mount - Front Drive Unit - RH (Remove and Replace) - Removal
- Mount - Front Drive Unit - RH (Remove and Replace) - Installation
READ NEXT:
Mount - Front Drive Unit - RH (Remove and Replace) - Removal
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed position.
Failure to follow this instruction could result in door glass
shat
Mount - Front Drive Unit - RH (Remove and Replace) - Installation
Installation
Use alcohol wipes to clean the mating surfaces between the RH
drive unit mount and drive unit.
Place a shear plate on the outboard side of the drive unit mount
so that
SEE MORE:
Frame - Seat Base - 2nd Row Cushion (Remove and Replace)
Removal
Remove the seat cushion (refer to procedure).
Remove the LH rear seat back rest assembly (refer to procedure).
Remove the RH rear seat back rest assembly (refer to procedure).
If the vehicle is equipped with the Subzero Weather package,
disconnect the 2 seat
Handle - Exterior Release - Door - Front - LH (Remove and Replace)
Removal
Remove regulator assembly (refer to procedure)
Make sure exterior release handle is fully retracted.
Disconnect handle harness connector.
Remove nuts (x4) securing door release assembly to reinforcement
(torque 9 Nm).
Carefully release door handle assembly from d
© 2019-2026 Copyright www.tesms.org
