Tesla Model S: Panel - Door Trim - LH - Front (Remove and Install)
READ NEXT:
Removal
Position the vehicle so that there is full access to the
driver's door.
Lower the window.
Open the door for access.
Remove the screws (x3) that secure the trim pad to
Installation
Installation procedure is the reverse of removal, except for the
following:
Caution: Do not reuse the heart flex clips; they are
one-time use only.
Vehicles
Removal
Remove the driver's door switch pack (refer to procedure).
Release the clips that secure the speaker cover to the door
trim.
Caution: Take care not to damage compo
SEE MORE:
Warning: "Jack mode" must
be activated on vehicles with air suspension before lifting the
vehicle. Failure to do this might lead to suspension damage and
could cause serious personal injury.
Note: Vehicles with air
suspension might need the suspension to be set to "High" or "Very
Removal
Remove backplate grip (refer to procedure)
Disconnect LED wiring and remove from door grip.
Installation
Install LED and connect wiring.
Install backplate grip.
LED - Door -