Tesla Model S Owners & Service Manuals

Tesla Model S: Subframe Assembly - Rear (Remove and Install)

Tesla Model S (2012-2026) Service Manual / Chassis / Subframe Assembly - Rear (Remove and Install)

READ NEXT:

 Subframe Assembly - Rear (Remove and Install) - Removal

Note: Loosen suspension fasteners by hand, then use a cordless electric drill with a 3/8 in drive adapter and a 3/8 in drive air ratchet wrench. Warning: Only technicians who have be

 Subframe Assembly - Rear (Remove and Install) - Installation

Installation Installation procedure is the reverse of removal, except for the following: Warning: Only use cleaning agents and solvents in a well-ventilated area.

 Subframe Assembly - Rear (Remove and Replace)

Removal Remove the rear drive unit: Small drive unit: Refer to procedure. Large drive unit: Refer to procedure. Remove the rear

SEE MORE:

 Starting/Discharging the System

Starting the System Press the emergency stop button to disable HV systems. Pull out the display/keyboard/trackpad tray. Press the red power button to turn on the on-board PC. Follow the onscreen instructions to log in to the system. Userna

 Wheel Arch Liner - Upper - Front - LH (Remove and Replace)

Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle. Removal Raise and support the vehicle (refer to procedure) Warning: Do not work on an incorrectly supported vehicle.

© 2019-2026 Copyright www.tesms.org