Tesla Model S: Trim - Rear Trunk - Side - RH (Remove and Replace)
Removal
- Remove the 'C' post rear trim. (refer to procedure)
- Remove the trunk side garnish trim.
- Remove the trunk floor trim. (refer to procedure)
- Peel back the rear edge of the trunk side trim panel and
disconnect the wiring harness.
Caution: Do not damage the wiring harness connection.
- Remove the RH trunk side trim.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Open the rear liftgate for access.
Release the tethers (x2) and clips (x2) that secure the trunk
cover to the body.
Remove the trunk cover.
Release the handle and remo
Removal
Open the hood.
Remove the lower carpet from the underhood storage area.
Remove the upper trim panel by pulling
Removal
Peel back the carpeting at the front of the underhood storage
unit.
Disconnect the emergenc
SEE MORE:
Tesla provides you with two Model S key cards, designed
to fit in your wallet.
To use a key card to unlock or lock Model S, position the
card as shown and tap it against the card reader located
approximately one third the way up of the driver's side
door pillar. When Model S detects the key car
Removal
Recover refrigerant from the vehicle (refer to procedure).
Remove the underhood storage unit (refer to procedure).
Remove the bolt that secures the high pressure pipe to the
compressor (torque 10 Nm).
Caution: Plug pipe connections to prevent in