Tesla Model S: Underhood Apron - LH (Remove and Replace)
Removal
- Open the hood.
- Release the lugs (x3) that secure the LH underhood apron to the
inner fender.
Caution: Take care not to damage component(s).
- Release and remove the LH underhood apron.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Remove the driver's seat (refer to procedure).
Place the seat on a clean work surface.
Remove the screw that secures the inner side cover to the seat
(torque 1 Nm).
Removal
Power the seat fully upward, away from the floor.
Remove the driver's seat outer side cover (refer to procedure).
Disconnect the seat height motor connector and harness.
SEE MORE:
Removal
Remove door handle for access (refer to procedure)
Position handle assembly on a soft working surface.
Remove door handle rear seal.
Release motor harness connector.
Remove cable ties securing door pressure sensor and motor
wiring.
Release motor wiring connec
Removal
Open the hood for access.
If the vehicle is rear wheel drive (RWD), remove the clips (x6)
that secure the acoustic panel to the hood and carefully peel back
the acoustic panel for access.
Mark the instal