Tesla Model S: Exterior fittings
Tesla Model S (2012-2026) Service Manual / Exterior fittings
- Wheel Arch Liner - Upper - Front - LH (Remove and Replace)
- Wheel Arch Liner - Rear - LH (Remove and Replace)
- Wheel Arch Liner - Lower - Front - LH (Remove and Replace)
- Panel - Aero Shield - Front (Remove and Replace)
- Panel - Aero Shield - Mid (Remove and Replace)
- Panel - Diffuser Tray - Rear (Remove and Replace)
- Rails - Diffuser Tray Rear - LH (Remove and Replace)
- Rear Lettering (Remove and Replace)
- Applique - Liftgate (Remove and Replace)
- Badge - Ludicrous Speed (Retrofit)
- Bracket - License Plate - Front (Retrofit)
- Door Mirror Assembly - LH (Remove and Replace)
- Glass - Door Mirror - LH (Remove and Replace)
- 'B' Post Trim Panel - LH (Remove and Replace)
- Brightwork - Body side - LH (Remove and Replace)
- Rocker Panel - LH (Remove and Replace)
- Pad - Lifting - Each (Remove and Replace)
- Panel - Cowl Screen (Remove and Replace)
- Assembly - Underhood Apron - Front (Remove and Replace)
- Underhood Apron - Center - Rear (Remove and Replace)
- Underhood Apron - LH (Remove and Replace)
READ NEXT:
Wheel Arch Liner - Upper - Front - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to pro
Wheel Arch Liner - Rear - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to pro
Wheel Arch Liner - Lower - Front - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to pro
SEE MORE:
Trim - Touch Screen Surround (Remove and Replace)
Removal
Remove the MCU/touch screen (refer to procedure).
Remove the screws (x6) that secure the touch screen surround
(torque 4 Nm).
Cut the cable tie that secures the Bluetooth antenna to the edge
clip on the bezel.
Remove the bezel from the MCU.
Remove the screws
Cover - Outer Side - Driver's Seat (Remove and Install)
Removal
Open both driver's side doors.
Power the seat height adjust fully upwards for access.
Remove the screw that secures the outer side cover to the seat
(torque 1 Nm).
Carefully release the outer side cover
© 2019-2026 Copyright www.tesms.org
