Tesla Model S: Wheel (Remove and Install)

Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle.

Note: Vehicles with air suspension might need the suspension to be set to "High" or "Very High" to allow the vehicle to be positioned and supported correctly on a vehicle lift.

Removal

1. Position the vehicle on a lift but do not lift it at this time.
2. If equipped, remove the lug nut covers.
3. Initially loosen the lug nuts (x5) (torque 175 Nm).

   Caution: Do not use an impact wrench to loosen tall lug nuts.

   

   1	Short lug nut
   2	Tall lug nut

4. Raise and support the vehicle (refer to procedure). Warning: Do not work on an incorrectly supported vehicle. Warning: To avoid personal injury, use appropriate equipment when performing this operation.
5. Remove the lug nuts (x5) and then remove the wheel.

Installation procedure is the reverse of removal, except for the following:

Caution: Tighten the lug nuts evenly using a diagonal sequence.

Caution: An impact wrench or electric wrench can be used only during the initial threading of the lug nuts. Use a torque wrench to fully tighten the lug nuts.

Caution: Use a 6 point socket to tighten tall lug nuts. Do not use a 12 point socket or a speciality socket on tall lug nuts.

Note: If wheels of a different diameter are installed, use Toolbox to change the vehicle configuration.

Note: Any time the TPMS sensors are not reinstalled in the same locations (for example, when rotating the tires), perform the TPMS sensor ID learn procedure:

• Baolong TPMS: (refer to procedure).
• Continental TPMS: (refer to procedure).

• Baolong TPMS: Use Toolbox to change the vehicle configuration, then reset the TPMS thresholds (refer to procedure).
• Continental TPMS: Use Toolbox to change the vehicle configuration.

READ NEXT: