Tesla Model S: Wheels and Tires
Tesla Model S (2012-2026) Service Manual / Wheels and Tires
- Tire - Front - LH
- Tire - Front - LH - Rebalance
- Wheel (Remove and Install)
- Wheels - Axle Set (Remove and Install)
- Wheels - Vehicle - Set (Remove and Install)
- Wheel Sensor - TPMS (Remove and Replace)
- Wheel Sensor - TPMS (Remove and Replace) - Removal
- Wheel Sensor - TPMS (Remove and Replace) - Installation
- TPMS Sensor - ID Learn Procedure - Baolong
- TPMS Sensor - ID Learn Procedure - Continental
- TPMS - Set Thresholds
READ NEXT:
Tire - Front - LH
Warning: Always read and
understand the tire equipment operator's manual before operating the
wheel balancer or tire changer.
Note: These instructions
are based on the Hunter TC3900 tire
Tire - Front - LH - Rebalance
Warning: Always read and
understand the tire equipment operator's manual and on-screen
instructions before operating the wheel balancer or tire changer.
Note: These instructions are
based on
Wheel (Remove and Install)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Note: Vehicles with air
suspension might need the suspens
SEE MORE:
Actuator - Latch - Hood - LH (Dual Motor) (Remove and Replace)
Removal
Remove the ankle catcher (refer to procedure).
Remove the LH and RH condenser ducts (refer to procedure).
Remove the plastic rivets (x3) that secure the center louver
assembly.
Note: The following image shows the center
louver assembly from the rear.
Unable to charge - Charge handle too hot
Check charge handle or charge port for debris
What this alert means:
Over temperature protection (latch off).
What to do:
Make sure the connector is fully inserted into the charge inlet in the
vehicle's charging port, is not covered by
anything, and there is no heat source nearby. If the issue per
© 2019-2026 Copyright www.tesms.org
