Tesla Model S Owners & Service Manuals

Tesla Model S: Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / Closures / Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

Removal

  1. Remove window glass (refer to procedure)
  2. Remove bolts (x3) securing door control unit to door and tie aside (torque 1 Nm).
  3. Remove screws (x6) securing regulator closing panel to door inner (torque 4 Nm).
  4. Release regulator access panel and tie aside.

    Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

  5. Remove waterproof tape to expose nuts.
  6. Remove nuts (x2) securing regulator to door upper fixed mounting (torque 10 Nm).

    Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

  7. Remove plugs (X2) to expose nuts in lower edge of door.
  8. Remove nuts (x2) securing regulator to door lower adjustable mounting (torque 10 Nm).
  9. Remove screws (x3) securing regulator motor to door inner (torque 2.4 Nm).

    Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

  10. Carefully collapse regulator assembly and withdraw through door opening. As soon as the wiring harness connection to the motor can be accessed, disconnect to prevent possible harness damage. Caution: Take care not to damage component(s).
  11. Remove regulator assembly from vehicle.

    Window Motor/Regulator Assembly - Front - LH (Remove and Replace)

Installation
  1. Installation procedure is the reverse of removal.
  2. Set regulator to witness marks from previous installation.
  3. Align glass to seals.

    READ NEXT:

     Window Motor/Regulator Assembly - Rear - LH (Remove and Replace)

    Removal Remove rear window glass (refer to procedure) Remove waterproof tape to expose nuts. Note: Components have been removed in this graphic to aid clar

     Seal - Body - Side - Front - Primary - LH (Remove and Replace)

    Removal Remove the 'B' post upper trim (refer to procedure). Release the clips (x3) that secure the leading edge of the seal to the body. Caution: Take care

     Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

    Removal Remove 'B' post upper trim (refer to procedure) Release clip (x1) securing rear door seal to body. Carefully release seal from rocker panel and work toward upper section o

    SEE MORE:

     Motor - Door - Exterior Handle - Front - LH (Remove and Replace)

    Removal Remove door handle for access (refer to procedure) Position handle assembly on a soft working surface. Remove door handle rear seal. Release motor harness connector. Remove cable ties securing door pressure sensor and motor wiring. Release motor wiring connec

     Fluids and Capacities

    Fluids Air conditioning Depending on its intended sales region, the air conditioning system is filled with R134a or 1234yf refrigerant. Refer to the label on the RH frunk trim. If oil needs to be added to the system, use only POE ND-11 or equivalent. Caution: Do not mix differe

    © 2019-2026 Copyright www.tesms.org