Tesla Model S: Autopark canceled
Take control
Autopark has been canceled. You need to park or finish parking your vehicle manually.
Once the parking maneuver is complete, apply the brakes and shift into Park. Your vehicle will otherwise remain free- rolling.
Autopark can be canceled due to many factors, including the following:
- Driver input or behavior
- Moving the steering yoke
- Pressing the accelerator pedal
- Pressing the brake pedal
- Opening a door and/or exiting the vehicle
- Pressing the Cancel button on the touchscreen
- Environmental / external conditions
- Steep slope / grade
- Weather conditions affecting visibility
- Curb cannot be detected
- A trailer is attached to the vehicle
- Vehicle system constraints
Autopark should be available again during your next drive.
If this alert persists throughout subsequent drives, schedule service at your earliest convenience. Your vehicle is OK to drive in the meantime.
For more information, see To Cancel Parking and Limitations.
Autopark aborted
Autopark has aborted and the Electronic Parking Brake has been applied. You need to park or finish parking your vehicle manually.
Once the parking maneuver is complete, apply the brakes and shift into Park. Your vehicle will otherwise remain free- rolling.
Autopark can abort due to many factors, including the following:
- Driver input or behavior
- Using the gear stalk
- Moving the steering yoke
- Pressing the accelerator pedal
- Pressing the brake pedal
- Opening a door and/or exiting the vehicle
- Pressing the Cancel button on the touchscreen
- Environmental / external conditions
- Steep slope / grade
- Weather conditions affecting visibility
- Curb cannot be detected
- A trailer is attached to the vehicle
- Vehicle system constraints
Autopark should be available again during your next drive.
If this alert persists throughout subsequent drives, schedule service at your earliest convenience. Your vehicle is OK to drive in the meantime.
For more information, see To Cancel Parking and Limitations.
READ NEXT:
Limited deceleration when accelerator is released
OK to drive - Use brake pedal as needed
Regenerative braking performance is temporarily reduced. The expected amount
of automatic deceleration is not
available when you lift your foot off the accele
Vehicle Hold feature unavailable
Keep brake pedal pressed while stopped
Vehicle Hold is currently unavailable due to system constraints. When
stopping, use the brake pedal to bring your
vehicle to a complete stop and keep your vehi
Cannot charge - Poor grid power quality possible
Retry / Try other charge location or Supercharging
Charging has stopped due to a condition that prevents your vehicle from
charging with AC power. DC fast charging /
Supercharging should still funct
SEE MORE:
Sensor - Wheel Speed - ABS - Rear - LH (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Removal
Raise and support the vehicle
(refer to procedure)
Remove road wheel for access
(refer to procedure)
Remove screw
Tire - Front - LH - Rebalance
Warning: Always read and
understand the tire equipment operator's manual and on-screen
instructions before operating the wheel balancer or tire changer.
Note: These instructions are
based on the Hunter GSP9700 wheel balancer. Some steps might be
different for other wheel balancers. Refe
