Tesla Model S Owners & Service Manuals

Tesla Model S: Coolant System - Check and Fill

Tesla Model S (2012-2026) Service Manual / Thermal Management / Coolant System - Check and Fill

Check & Top-Up

  1. Remove coolant cap from reservoir.
  2. Fill reservoir to correct level.

    Check & Top-Up

  3. Reinstall the cap.

    READ NEXT:

     Cooling System - Vacuum Refill

    Note: Make sure at least 14 L of the specified coolant is available before beginning this procedure. Caution: Use the specified coolant only. In this manual, refer to General Informati

     Radiator (Remove and Replace)

    Removal Drain the cooling system (refer to procedure). Remove the front fascia assembly for access (refer to procedure). Release the clamps (x2) that secure the feed and return ho

     Reservoir Assembly - Coolant (Remove and Replace)

    Warning: If the 12V power supply is disconnected, do not attempt to open any doors with door glass in closed position. Failure to follow this instruction could result in door glass shat

    SEE MORE:

     Spring and Damper Assembly - Rear - LH (Remove and Replace)

    Removal Remove the LH rear wheelarch liner (refer to procedure). Remove the parking brake caliper (refer to procedure). Remove the mid aero shield (refer to procedure). Remove the bolt that secures the upper link to the knuckle (torque 140 Nm). Support the rear suspensio

     Seal - Door - Rear - C Pillar - Margin - LH (Remove and Replace)

    Removal Remove door trim (refer to procedure) Release clips (x3) securing flap seal end to door. Note: Components have been removed in this graphic to aid clarity. Caution: Take care not to damage component(s). Carefully release remai

    © 2019-2026 Copyright www.tesms.org