Tesla Model S: Cover - Seat back - 2nd Row Seat - RH (Remove and Replace)
Removal
- Remove pivot lock (refer to procedure)
- Release and remove latch cover from seat back.
- Carefully release cover from seat back frame.
- Remove cover and foam assembly from frame.
- Release cover from foam to gain access to hog rings and remove
hog rings securing cover to foam
- Remove cover from foam.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Remove the driver's side lower dash trim (refer to procedure).
Rotate the brake light switch 45 degrees clockwise and release
it from the brake pedal assembly.
Removal
Remove the brake light switch (refer to procedure).
Caution: The brake light switch is a one time use
component. Ensure that a new switch is used durin
SEE MORE:
Note: The GSM antenna is a component within the door
mirror assembly. If the GSM antenna develops a fault, the whole
mirror assembly must be replaced.
Removal
Remove the door mirror assembly (refer to procedure).
Remove the door mirror
The front and rear motors in Model S generate power
when the wheels spin. Always transport Model S with all
four tires off the ground. Ensure that the tires are unable
to spin at any time during transport.
WARNING: NEVER TRANSPORT YOUR VEHICLE
WITH THE TIRES IN A POSITION WHERE THEY
CAN SPI