Tesla Model S Owners & Service Manuals

Tesla Model S: Face Level Vent - Front Passenger's

    READ NEXT:

     Face Level Vent - Front Passenger's - Outer (Remove and Replace)

    Removal Remove RH instrument panel finisher assembly (refer to procedure) Remove screws (x3) securing passenger outer face vent to trim (torque 1 Nm). Remove vent from trim.

     Face Level Vent - Front Passenger's - Inner (Remove and Replace)

    Removal Remove RH instrument panel finisher assembly (refer to procedure) Remove screws (x3) securing passenger inner face vent to trim (torque 1 Nm). Remove vent from trim.

     Assembly - Bin - Storage Center Compartment (Remove and Replace)

    Removal Remove center console carpet. Caution: Apply contact adhesive to mating faces if bond has been broken. Release clips (x4) securing closing p

    SEE MORE:

     Subframe Assembly - Rear (Remove and Install) - Removal

    Note: Loosen suspension fasteners by hand, then use a cordless electric drill with a 3/8 in drive adapter and a 3/8 in drive air ratchet wrench. Warning: Only technicians who have been trained in High Voltage Awareness are permitted to perform this procedure. Proper personal pr

     Gearbox Fluid - Large Rear Drive Unit (Remove and Replace)

    Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle. Drain & Refill Raise and support the vehicle (refer to procedure). Warning: Do not work on an incorrectly supported vehicle.

    © 2019-2026 Copyright www.tesms.org