Tesla Model S: Foam - Cushion
Foam - Cushion - Driver's Seat (Remove and Replace)
RemovalNote: This component cannot be serviced individually. To service this component, perform the following: Replace the driver's seat trim and foam assembly (refer to procedure).
Installation
Installation procedure is the reverse of removal.
Foam - Cushion - Front Passenger's Seat (Remove and Replace)
RemovalNote: This component cannot be serviced individually. To service this component, perform the following: Refer to one of the following:
- North America: Replace the passenger's seat base assembly (refer to procedure).
- Europe/Asia Pacific: Replace the passenger's seat trim and foam assembly (refer to procedure).
Installation procedure is the reverse of removal.
Trim and Foam Assembly - Front Passenger's Seat (Remove and Install)
RemovalCaution: This component cannot be serviced individually on North American vehicles. If working on a North American vehicle, replace the passenger's seat base assembly (refer to procedure). Removal of the front passenger's seat trim and foam assembly is similar to the driver's side (refer to procedure).
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Latch - Seat Back - 2nd Row Seat - LH (Remove and Replace)
Removal
Remove LH pivot lock (refer to procedure)
Release and remove latch cover from seat back.
Carefully release cove
Cover - Seat back - 2nd Row Seat - RH (Remove and Replace)
Removal
Remove pivot lock (refer to procedure)
Release and remove latch cover from seat back.
Carefully release cover f
SEE MORE:
Cleaning the Exterior
To prevent damage to the paint, immediately remove
corrosive substances (bird droppings, tree resin, dead
insects, tar spots, road salt, industrial fallout, etc.). Do
not wait until Model S is due for a complete wash. If
necessary, use denatured alcohol to remove tar spots
and stubborn grease s
Headlight - Adjust - North America
North America (SAE)
Prepare a work area for adjusting the headlights:
The area is darkened.
The ground is flat and level.
There is a wall with a white matte surface.
Note: The wall should be at least 6 ft (1.8 m)
high and 12 ft (3.7 m) wide.
