Tesla Model S: Headlight Assembly - LH (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Electrical / Headlight Assembly - LH (Remove and Replace)
Removal
- Remove front fascia for access (refer to procedure)
- Disconnect headlight connectors (x2).
- Remove bolts (x4) securing headlight to carrier and fender
(torque 4 Nm).
Note: LH wheel arch liner has been removed in illustration to aid clarity.
- Remove headlight.
- Installation procedure is the reverse of removal, except for the following:
- Check headlight to fender profiles and gaps.
- Check and adjust headlight as necessary.
READ NEXT:
Tail Light Assembly (Non-Motorized Charge Port) - LH (Remove and Replace)
Special tool required for this procedure:
Supplier
Part Number
Description
Tesla
1054190-0
Tail Light Assembly (Motorized Charge Port) - LH (Remove and Replace)
Special tool required for this procedure:
Supplier
Part Number
Description
Tesla
1054190-0
Lamp - Brake - High Mounted (Remove and Replace)
Removal
Remove liftgate glazing (refer to procedure)
Position liftgate glazing on suitable glazing stand.
Note installed position of Central High Mounted Stop Lamp (CHMSL).
Us
SEE MORE:
Air Spring Module - Rear - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to procedure).
Warning: Do not work on an incorrectly supported
vehicle.
Wheel (Remove and Install)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Note: Vehicles with air
suspension might need the suspension to be set to "High" or "Very
High" to allow the vehicle to be positioned and supported corre
© 2019-2026 Copyright www.tesms.org
