Tesla Model S: Seal - Door Rear Outer Belt - LH (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Closures / Seal - Door Rear Outer Belt - LH (Remove and Replace)
Removal
- Lower window glass.
- Using a suitable tool release outer belt seal, release leading
edge and work rearward.
Caution: Protect paintwork from possible damage during this procedure.
Caution: Take care not to damage component(s).
- Release hooked end from door skin and remove seal.
- Installation procedure is the reverse of removal.
- In the event of seal being damaged at rear end, it will be necessary to replace component.
- Check for smooth operation when opening and closing window glass.
READ NEXT:
Seal - Sliding Glass - Panoramic Roof (Remove and Replace)
Removal
Remove the sliding roof glass (refer to procedure) .
Release the rear ends of the main seal from beneath the stop
bumper seal.
Wheel Arch Liner - Upper - Front - LH (Remove and Replace)
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Removal
Raise and support the vehicle (refer to pro
SEE MORE:
Assembly - Mesh Grille - Defrost (Remove and Replace)
Removal
Remove the top pad for access to the mesh grille (refer to
procedure)
Remove the defrost mesh grille.
Installation
Installation procedure is the reverse of removal.
When installing the new mesh grille, ensure that all 4 retaining
cli
Sensor - Wheel Speed - ABS - Front - LH (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.Removal
Remove the road wheel for access
(refer to procedure).
Remove the screws (x3) that secure the wheel
speed sensor harness brac
© 2019-2026 Copyright www.tesms.org
