Tesla Model S Owners & Service Manuals

Tesla Model S: Slave Charger - LH - 2nd Generation (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / High Voltage System / Slave Charger - LH - 2nd Generation (Remove and Replace)

READ NEXT:

 Slave Charger - LH - 2nd Generation (Remove and Replace) - Removal

Note: This procedure describes how to remove and install the 2nd generation slave charger. If the vehicle is equipped with a 1st generation slave charger, refer to procedure 44100102 (refer

 Installation, Configuration, and Coolant Purge

Fully clean the area before installing the new charger. Note: Have an assistant hold up the front of the HVJB 20-30 mm until the coolant hoses have been secured to the charger. Position

 Master Charger - RH - 1st Generation (Remove and Replace)

Note: This procedure describes how to remove and install the 1st generation master charger. If the vehicle is equipped with a 2nd generation master charger, refer to procedure 44102202 (refer

SEE MORE:

 Fork and Control Link - Door - Exterior Handle - Front - LH (Remove and Replace)

Removal Remove Door Motor (refer to procedure) Remove Door Grip (refer to procedure) Remove press sensor screw. Release door press sensor wiring connector. Remove pivot pin connecting control link to PVT cartrid

 HV Harness - Rear Drive Unit to HVJB

Warning: Only technicians who have been trained in High Voltage Awareness are permitted to perform this procedure. Proper personal protective equipment (PPE) and insulating HV gloves with a minimum rating of class 00 (500V) must be worn any time a high voltage cable is handled. Refer

© 2019-2026 Copyright www.tesms.org