Tesla Model S: Wind Deflector (Remove and Replace)
Tesla Model S (2012-2026) Service Manual / Roof / Wind Deflector (Remove and Replace)
Removal
- Remove the LH and RH wind deflector arms (refer to procedure).
-
Release the wind deflector from the clips on
the deflector blade.
Installation procedure is the reverse of removal.
Caution: Ensure that the wind deflector is secure before returning the vehicle to the customer.
READ NEXT:
Motor - Sunroof - LH (Remove and Replace)
Removal
If the vehicle is equipped with premium audio,
remove the premium boost amplifier module
(refer to procedure).
Disconnect the sunroof motor harness connector.
Motor - Sunroof - RH (Remove and Replace)
Removal
Remove glove box assembly
(refer to procedure)
Disconnect sunroof motor harness connector.
Remove screws (x3) securing sunroof motor to
'A' post (torque
SEE MORE:
Mobile Connector control box temperature high
Maximum charge rate reduced
Charge current has been temporarily reduced because the Mobile Connector has
detected increased temperature
inside its control box housing.
Make sure the Mobile Connector is not covered by anything, and that there is no
heat source nearby. If the problem
persists in
Media Control Unit - Touch Screen (Remove and Replace)
Backup
Connect a laptop with Toolbox 2.0 or later to the vehicle.
Select Panels > Gateway and Center Display > MCU
Cloner.
Click MCU Backup to backup the MCU files.
If the backup is successful, click MCU Disable to disable the
MCU. If the backup was not successful, co
© 2019-2026 Copyright www.tesms.org
