Tesla Model S Owners & Service Manuals

Tesla Model S: Motor - Sunroof - RH (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / Roof / Motor - Sunroof - RH (Remove and Replace)

Removal

  1. Remove glove box assembly (refer to procedure)
  2. Disconnect sunroof motor harness connector.
  3. Remove screws (x3) securing sunroof motor to 'A' post (torque 5 Nm).

    Motor - Sunroof - RH (Remove and Replace)

  4. Release sunroof motor assembly and disconnect module from drive tube.
  5. Remove sunroof motor module.

    Motor - Sunroof - RH (Remove and Replace)

Installation

Installation procedure is the reverse of removal.

    READ NEXT:

     Chassis

     Subframe Assembly - Rear (Remove and Install)

     Subframe Assembly - Rear (Remove and Install) - Removal

    Note: Loosen suspension fasteners by hand, then use a cordless electric drill with a 3/8 in drive adapter and a 3/8 in drive air ratchet wrench. Warning: Only technicians who have be

    SEE MORE:

     PCB - Door - Exterior Handle - Front - LH (Remove and Replace)

    Removal Remove fork and control link for acces (refer to procedure) Remove screws (x3) securing PCB to housing (torque 1.5 Nm). Release PCB pressure sensor from housing and disconnect wiring. Remove assembly

     Refrigerant evacuation and recharging

    The HVAC and battery coolant circuits are sealed to prevent the discharge of refrigerant. The refrigerant must be recovered before any removal of system components using the recommended equipment.Two ports are provided on the HVAC system and are accessible under the hood. Warning: Ens

    © 2019-2026 Copyright www.tesms.org