Tesla Model S Owners & Service Manuals

Tesla Model S: Applique - Fascia - Front - 2nd Generation (Remove and Replace)

Tesla Model S (2012-2026) Service Manual / Body / Applique - Fascia - Front - 2nd Generation (Remove and Replace)

Note: This procedure describes how to remove and replace the 2nd generation front fascia applique. If the vehicle is equipped with a 1st generation front fascia applique, refer to procedure 10011402 (refer to procedure).

Removal

  1. Remove the front fascia applique (refer to procedure).
  2. Remove the parking sensors from the applique.
  3. Remove the bright trim from the applique.

Caution: Take care not to damage component(s).

Installation
  1. Transfer the parking sensors and bright trim to the new applique.
  2. Install a new Tesla "T" badge.
  3. Reinstall the applique.

    READ NEXT:

     Grill - Fascia - Front (Remove and Replace)

    Removal Vehicles with 1st generation front fascia applique only: Remove the front fascia applique refer to procedure. Vehicles with 2nd generation front fascia applique only: Remo

     Chin Spoiler Assembly (Remove and Replace)

    Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle. Removal Remove the front fascia refer to procedure.

     Fascia Assembly - Rear (Remove and Install)

    Warning: If the vehicle has air suspension, activate "Jack" mode on the touchscreen before raising and supporting the vehicle. Removal Position the vehicle in preparation for rai

    SEE MORE:

     Calibration - Panoramic Roof Assembly

    Check Close panoramic roof glass using touch screen. Connect a laptop with Toolbox to the vehicle. In Toolbox, select Views > Body/Security > Panoramic Sunroof, then select "Calibrate". The sunroof opens and closes. When calibration is complete

     Seal - Body - Side - Rear - Primary - LH (Remove and Replace)

    Removal Remove 'B' post upper trim (refer to procedure) Release clip (x1) securing rear door seal to body. Carefully release seal from rocker panel and work toward upper section of seal. Release remaining seal from brightwork.

    © 2019-2026 Copyright www.tesms.org