Tesla Model S: Safety and Restraint
Tesla Model S (2012-2026) Service Manual / Safety and Restraint
- Air bag - Driver's (Remove and Replace)
- Knee Air bag - Driver's (Remove and Replace)
- Air bag - Front Passenger's (Remove and Replace)
- Knee Air Bag - Front Passenger's (Remove and Replace)
- Curtain Air bag - Driver's (Remove and Replace)
- Seat Belt Assembly - 1st Row - LH (Remove and Replace)
- Buckle Assembly - 1st Row - LH (Remove and Replace)
- Seat Belt Assembly - 2nd Row - LH (Remove and Replace)
- Buckle Assembly - 2nd Row - LH (Remove and Replace)
- Seat Belt Assembly - 2nd Row - Center (Remove and Replace)
- Seat Belt Assembly - 3rd Row - LH (Remove and Replace)
- Buckle Assembly - 3rd Row - LH (Remove and Replace)
- Pre-Tensioner - Outboard Lap - 1st Row - LH (Remove and Replace)
- Pyrotechnic Fuse (Remove and Replace)
- Sensor - Intrusion - Door - Front (Remove and Replace)
- Sensor - Impact - Front (Remove and Replace)
- Sensor - Impact - B Pillar (Remove and Replace)
- Sensor - Impact - C Pillar (Remove and Replace)
- Sensor - Occupant Classification - Front Passenger's Seat - Calibration
- Sensor - Pedestrian Protection (Remove and Replace)
- Actuator - Pedestrian Protection - LH (Remove and Replace)
READ NEXT:
Air bag - Driver's (Remove and Replace)
Warning: If the 12V power supply is disconnected, do
not attempt to open the front doors with door glass in closed
position. Failure to follow this instruction could result in
door glas
Knee Air bag - Driver's (Remove and Replace)
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed
position. Failure to follow this instruction could result in
door glass shat
Air bag - Front Passenger's (Remove and Replace)
Note: Removing the passenger's front airbag destroys the
instrument panel top pad.
Removal
Remove the top pad (refer to procedure)
Note: The top pad is
SEE MORE:
Assembly - Instrument Panel Lower - RH (Remove and Replace)
Removal
Remove the RH instrument panel side cover assembly (refer to
procedure).
Note: LH panel is illustrated; RH removal is
identical.
Using a suitable tool, release the clips (x13) that secure the
trim to the dash substrate.
Pressure Transducer - Low Pressure (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure).
Remove the underhood storage unit (refer to procedure).
Disconnect the electrical connector from the pressure
transducer.
Use a wrench to remove the pressure transducer from
the
© 2019-2026 Copyright www.tesms.org
